15
BEFORE EACH USE
1. Check bagger parts for wear, deterioration or
damage. Replace ONLY with Gravely original
service parts before operating.
2. Make sure counterweights are installed.
3. Ensure all hardware is tight.
IMPORTANT: Check tool-less hardware often. Tighten as
needed.
4. Remove any grass buildup from bagger parts.
5. Ensure hose is fastened securely on upper boot
and blower assembly.
6. Ensure mesh bags are installed, and the bagger
cover is closed and securely latched.
BAGGING
Starting
1. Start engine and engage PTO according to unit
owner’s manual.
2. Set throttle to full.
3. Choose a slow ground speed.
Shut Off
1. Disengage PTO.
2. Shut off unit according to unit Owner/Operator’s
manual.
EMPTYING MESH BAGS
If bagger stops picking up grass clippings, mesh bags
may be full.
To empty bags:
1. Disengage PTO, stop engine and remove ignition
key. Wait for all moving parts to stop before leaving
operator’s position.
2. Empty the grass from each bag.
3. Clean out hose.
4. Close and latch cover.
UNCLOGGING BAGGER
If hose or blower assembly gets clogged, stop forward
motion and allow unit to clear itself. If unit will not clear
itself, unclog the hose and/or blower assembly manually
as instructed below.
1. Stop engine and remove ignition key. Wait for all
moving parts to stop.
2. Lift thumb latch on inlet assembly remove hose
(figure 16).
3. Remove hose from blower assembly.
OPERATION
WARNING: AVOID INJURY. Read and
understand the entire Safety section before
proceeding.
WARNING: Lower attachment, stop engine, and
remove key to prevent unauthorized use. DO
NOT park on slopes.
WARNING: MOVING PARTS can cut or
amputate body parts.
NEVER attempt to clear blower assembly while
engine is running.
ALWAYS stop engine, remove key, and wait for
moving parts to stop.
Sharp edges can cut. Movement of parts can
cut off fingers or a hand. Wrap blade(s), wear
sturdy gloves and use extreme caution when
working near blades or impeller.
WARNING: PINCH POINT! Use extreme
caution when unclogging blower assembly.
Impeller can cut or pinch your hand, even when
not in operation. Wear sturdy gloves when
working near impeller.
Cover Assembly
Thumb Latch
Inlet Assembly
5/16" Wing
Bagger Mount
Blower Assembly
Bag Assembly
Figure 16
Hose
To Next Page
Loading...
Need help?
General
