Gravely 424 - Page 54

3.
Xemove
cable
from
positive post
of battery.
7,
Turn
off fuel and separate
fuel line.
8.
Sepirrate
wiring
harness at
connector.
9. Separate
tilil light
wire
(if
so
equipped).
10. nemove
wire
from
starttr
motor.
ll. Disctrn:rect throttle and choke cables.
19. Support
tractor frame
just
in
front of
the
PTO and
to frame.
r*move the two boltr
and two nuts securiag
chassis
ATTACI.{
ME I'1
THX
OVYSI,'
T
SXIFTEN
ARM
Sil
tPPtA
r c cr rr Q. v
FiN
ICN
ELL}TC14 SGG
sHArr
figurc
6d
Figure 67
13. Roll
chassis
back from frame.
14. Lower engine
to
foor.
15.
Remove advance
casting coverplate
-
dog clutch assembly.
16.
iemove the attachment throw out shifter
arm
-
sbipper
sha{t
assembly.
17.
Remove clutch dog from
pinion
shaft.
18.
Remove
pinion
slaft.
Carefully check all
parts
for
wear
or
binding,
Sight
down
splines of
pi::icn
shaft to see if
the shaft is
twisted.
Careftrlly
check the bearings of the
advance
casting
cover
plate
for
wear.
If
there
was
no
gaslet
under the shipper shaft
guide
on the advance
castirg,
be sure
to reassemble
using a
gasket.
If the PTO
seemed
not
to
be engaging
fully,
reassemble
using two
attachment
gaskets
betweel
the
advance
casting
and the
cover
plate
assemlly,
53