Gravely 812 - Front-Mount Attachments

Front Mounted
Attachments
38
-
Inch
Snowblower
44
-
Inch
Snowblower
Ihe 19075E1
Front Drive
Kit
is required.
\\_-\
\S_-:
I
I
I
_L_
\
I
I
L-
I
I
I
I
-
-
L't\.
/,'-\\'
t(t\
"
\--l
I
\*-,/
.'
,...:..
$l''
::.l:rr
,i:,ri{l:
J
&t;
ffi
ffi
ffis
,ffi
Figure 17
L lnstall the Front
Drive Kit on the tractor
following
instructions
witli the kit.
2.
Slide
the Double
Joint
Assembly
on
forward
drive
shaft. Position tractor
approximately
two inches
from
the snowblower.
3.
Start the
Double
Joint
Assembly
on
the
shaft of the
snowblowcr.
Roll tractor forward
until
the frame
on
the
snowblor,ver
fits in
the latches
on
the
bracket
as-
semblies
on
the
tractor. Close
thc latches
and se-
cure
in place
with hairpin
cotters. Raise
snowblower
stand and
secure in the raised
position.
4. Insert the
Push
Rod Guide Weldment into the
Push
Rod
and
install
irr the
top
hole
of the lift lever
shaft
weldment
of the tractor.
Sccure r,vith
washer
and
!ralrpin
cotter, Insert the
Push rod
through
the
hole
on the frame
of the
snowblower
and
-secure
with u'asher
and
hairpin
cotter.
&!
{i
,r
:$
Figure
19
CAUTION:
Use extreme
care when operating
Snow-
blower. Keep hands
and feet away
when auger
and fan
are turning. Stop engine
and
blower before making
any
adjustments
or clearing
chute
of
blockage.
Removal
CAUTION:
Be sure the PTO
is disengaged
and engine
stopped.
1. Lor,ver
Snowblower. Lower
stand and
secure.
Re-
move hairpin
cotters, raise
the latches
in raised po-
sition. Remove
Push
Rod from
snor.vblorvcr
and
Push
Rod Guide Weldment
from
tractor.
2"
Roll tractor away from
snowblower.
Double
fount
Assembly
will slide
off snowblower
shaft
or fonvard
drive
shaft. Ren'rove
Double
Joint
Asscrnbly
from
the
snowblor,ver shaft
or the iorward
drive shaft.
Remove
the drive shaft
by pulling
on the locking
collars on the
universal
joinls
and slicle
the
drivc
shaft
off the PTO
shaft
ancl the shaft
through
the
front axle.
It
is
not necessary
to remove
the Front
Bracket Assemblies.
Figure
18
I1