EasyManuals Logo

Gravely ZT HD 44 Owner's/Operator's Manual

Gravely ZT HD 44
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #32 background imageLoading...
Page #32 background image
EN - 32
SHORT TERM
NEVER spray unit with high-pressure water
or store unit outdoors.
Inspect unit for visible signs of wear,
breakage or damage.
Keep all nuts, bolts and screws properly
tightened and know unit is in safe working
condition.
Store unit in a cool, dry protected area.
LONG TERM
Clean unit thoroughly with mild soap and low
pressure water and lubricate (See Lubricate
Unit on page 24 in Maintenance). Touch up
all scratched painted surfaces.
Remove weight from wheels by putting
blocks under frame or axle.
When storing unit for extended periods of
time, remove all fuel from tank and carburetor
(run dry). Refer to Engine Manual.
Clean and charge the battery. Charge battery
every three to four weeks when storing unit.
Fuel System
Gasoline left in the fuel system for extended
periods without a stabilizer will deteriorate,
resulting in gum deposits in the system.
These deposits can damage the carburetor
and the fuel hoses, filter and tank. Prevent
deposits from forming in the fuel system
during storage by adding a quality fuel
stabilizer to the fuel. Follow the
recommended mix ratio found on the fuel
stabilizer container.
To treat the fuel system for storage:
1. Add fuel stabilizer according to
manufacturers’ instructions.
2. Run engine for at least 10 minutes after
adding stabilizer to allow it to reach the
carburetor.
NEVER store the engine with fuel in the fuel
tank inside of a building with potential
sources of ignition.
To Take the Unit Out of Storage
1. Refer to the engine service manual to
prepare the engine for service.
2. Put fresh, clean fuel in the fuel tank.
3. Begin the maintenance schedule.
4. Charge and install the battery.
STORAGE
WARNING: AVOID INJURY. Read
and understand entire Safety
section before proceeding.
ACCESSORIES
Part No. Description
79104400 Mulching Kit 44" Decks
79104500 Mulching Kit 48" Decks
79213500 Mulching Kit 52" Decks
79213600 Mulching Kit 60" Decks
79206700 Striper Kit
79104100 Discharge Cover Kit 44"
Decks
79104200 Discharge Cover Kit 48"
Decks
79104300 Discharge Cover Kit 52"
Decks
79213400 Discharge Cover Kit 60"
Decks
79202700 Headlight Kit
79104900 Bagger Adapter Kit 60" Decks
79104800 Bagger Adapter Kit 52" Decks
79104700 Bagger Adapter Kit 48" Decks
79104600 Bagger, Adapter Kit 44" Decks
89100300 HD Series Bagger
79102000 Hub Cap Set (2) Gravely 10"
79102300 Kit, Universal Flextend
79103600 Kit, Hex Striper
79103800 Kit, Sunshade
79210300 Kit, OC Chute Baffle 44", 48",
52"
79210500 Kit, OC Chute Baffle 60"
79210600 Wheel Covers Set (2) 6"
79103900 Vacuum Baffle Kit – 44"
79104000 Vacuum Baffle Kit 48"
79101200 Vacuum Baffle Kit 52"
79208600 Vacuum Baffle Kit 60"

Other manuals for Gravely ZT HD 44

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Gravely ZT HD 44 and is the answer not in the manual?

Gravely ZT HD 44 Specifications

General IconGeneral
Engine BrandKawasaki
Cutting Width44 inches
Deck Material10-gauge steel
Engine Size726 cc
Cutting Height1.5 - 4.5 inches
Spindle MaterialAluminum
SeatHigh Back
Ground Speed Forward8 mph
Ground Speed Reverse4 mph

Related product manuals