CCT10/CCT20 USER MANUAL
4
What is inside Box
AC/DC adaptor (110V)
Counting scale CCT 10/20 Scale, with adhesive film covered platter. Two parts are separated to
protect the load cell during transportation.
Two wire seals. The wire seal is used usually by the inspector of Department of Weight and
Measure or authorized dealer. The wire seal is threaded through a metal rode that protrudes
through the bottom of the device and also through a hole in the scale base adjacent to the metal
rode.
Set up the Scale
Place the scale on a stable, level surface out of the way of air currents. The scale must
be level during use. Adjust the feet and use the integrated bubble at the front of the scale
to achieve level. Be sure that scale does not rock back and forth. Ensure no weight is on
the pan when turning on the scale. Scale is operated using the rechargeable battery. AC
adaptor is used to charge the battery, and scale can operate without DC adaptor.
LCD Display
CCT10
Size: 77 mm x 27 mm X 2.8 mm
Font height: 16 mm
To Next Page
Loading...
