15
7.6 Names and functions of each button of wireless remote controller
NOTE:
Make sure that there are no obstructions between the receiver and wireless remote control.
The wireless remote control signal can be received at the distance of up to about 10m.
Do not drop or throw the wireless remote control.
Do not let any liquid flow into the wireless remote control or put it directly under the sunlight or any extremely hot places.
When the system stops and restarts, it can resume its original running mode and the outdoor unit will run after a while.
SWING button
When it is pressed, the
guide louver starts to swing
at the stated angle and stops
when it is pressed again.
FAN button
Each time this button is
pressed, fan speed will change
in the following order:
AUTO FAN
TEMP. button
Each time “ ” is pressed,
the set temperature will be
increased by 1℃ and each time
“ ” is pressed, the temperature
will be decreased by 1℃.
In Cool mode, room temperature
setting range is 16℃-30℃.
In DRY mode, room temperature
setting range is 16℃-30℃.
In HEAT mode, room temperature
setting range is 16℃-30℃.
In AUTO mode, temperature cannot
be adjusted.
indicates COOL mode.
indicates DRY mode.
indicates FAN mode.
indicates HEAT mode.
MODE button
Press this button
successively to change
running mode in the
following order.
AUTO
On/Off button
Press the button to turn on
the unit. Press the button
once again to turn off the
unit.
To Next Page
Loading...
