Gree Bright Series

Operating Procedures / Photos
Disassemble Front Case
Unclench the three screw covers,unscrew the three
screws fixing the front case, loosen the fore-and-aft
clasps and remove the front case.
(refer to Fig. 7-4)
Screw Screw Cover
Fig. 7-4
Disassemble Cover of Electric Box
Loosen the three clasps, and remove the cover of the
electric box.
(refer to Fig. 7-5)
clasps
Fig. 7-5
Disassemble Water Tray
Loose the clasp at the left side, and disconnect
the terminal of the stepping motor and take out
the water tray .
( Pay attention not to damage the drainage pipe).
(refer to Fig. 7-6;7-7)
clasp
Water Tray
Fig. 7-6
Fig. 7-7
terminal
Bright Series