Gree GCF220BKNA - Maintenance for Water Tray and Filter Sub-Assy

16
Maintenance for Water Tray and
Filter Sub-assy
1.Remove of water tray and fi lter sub-assy
(1) Remove water tray (See P9).
(2) Pull out the water tray and remove the fi lter
sub-assy.
●
Hold the bottom concave of water tray and pull out.
●
Slowly pull out the water tray as there’s water in the
tray.
●
Hold up the bottom of water tray when moving it.
1. Assembly of water tray
①
Assemble fi lter
sub-assy.
②
Press it until a
“crack” is heard.
Assemble the water tray and fi lter as the picture
shows direction.
●
Assemble the water tray and fi lter sub-assy
as original sample.
Incorrect assembly might cause operation
failure.
●
Wipe it with soft cloth or brush to get rid of the dirt.
●
Wipe the scale with soft cloth or brush dipping
with water or Citric acid warm water, then wash
with water.
Requirement
●
Do not remove the fl oater and degerming agent
box.
●
The unit cannot operate normally without the
fl oater and the water will be with odour soon
without the degerming agent box.
●
For different water quality and environment, the
water in water tray will be color changed
because of the scale. Maintain the water tray as
above stated.
●
Please assemble it as following picture.
▲
▲ ▲
Maintenance
standard
once a month or whenever there’s
peculiar smell or dirt
Maintenance
method
water clean
Correct assemble:
1. Assemble the fl oater
from the lower of
bulge on water tray.
2. Insert the shaft of
fl oater into water tray
hole.
Incorrect assemble:
The fl oater hangs
at the bulge of the
fl oater.
Degerming agent box.
Floater
2.Assembly of water tray and fi lter sub-
assy
2. Assembly of water tank. (See P9)
3.Water tray
4.Floater fall off from the water tray
Floater