38
Service Manual
Installation and Maintenance
ProcedureStep
humidity sensor
clasps
face-piece assembly
5.Remove face-piece assembly
4.Remove electric box cover
7.Remove handle
6.Remove cover plate
electric box cover
screws
Unscrew screws xing face-piece, Open
the clasps, remove humidity sensor and
wiring connecting main board then pull
the face-piece assembly outwards.
Unscrew 4 screws xing cover plate to
remove it.
Unscrew 2 screws xing electric box
cover to remove it.
Lift the handle, along horizontal direction
to move it outwards, then remove the
handle.
cover plate
screws
handle
screws
To Next Page
Loading...
