13
3. Water Bucket
Every few weeks, clean the bucket to prevent growth of mold, mildew and
bacteria. Use soft brush to clean the bucket and then rinse it.
1. Take out the water bucket and then pour out the residual water.
2. Press down 4 buckles around the water bucket. Lift up the drain lid.
3. After cleaning, replace the drain lid and make sure the float of water
bucket is placed properly. The side with foam plastic should be beneath
the drain lid. Do not remove the foam plastic on the float.
GDN20AV-K5EBA1A
Buckle
Drain Lid
1. Take out the water bucket and then pour out the residual water.
2. As shown in the figure, rotate the handle to make it out from the shaft
hole and then remove the handle. Open the four clasps on water tank
cover and then remove the cover.
3. After cleaning, replace the drain lid and handle, and make sure the float
of water bucket is placed properly. The side with foam plastic should be
beneath the drain lid. Do not remove the foam plastic on the float.
GDN40AW-K5EBA1A
Buckle
Drain Lid
handle
shaft hole
To Next Page
Loading...
