Why my Gree Air Conditioner unit doesn’t work?
Your Gree Air Conditioner might not be working due to several reasons: a cut-off fuse or circuit breaker (replace the fuse or reset the circuit breaker); a power failure (restart the unit when power is restored); disconnected power supply (connect the power); insufficient remote controller power (replace the battery); or the remote controller being out of range (ensure it's within 8m).
What to do if my Gree Air Conditioner has abnormal cooling or heating?
If your Gree Air Conditioner isn't cooling or heating properly, check for these possible causes: blocked air inlets or outlets (clear any obstructions); improper temperature, fan speed, or wind direction settings (adjust via the remote or wired controller); open doors or windows (close them); direct sunshine (use curtains or louvers); too many people or heat sources in the room (reduce these); or a blocked and dirty filter (clean the filter).
What to do if my Gree Air Conditioner runs but stops immediately?
If your Gree Air Conditioner starts but stops right away, it might be because the air inlet or outlet of the indoor or outdoor units is blocked. Clear any obstructions to resolve this.
Essential safety instructions to prevent injury, fire, or equipment damage.
Essential safety measures to follow during unit installation and handling.
Procedures for vacuumizing and drying the refrigerant system for optimal performance.
Methods for calculating and adding refrigerant to the system.
Important considerations and warnings for the unit debugging process.
Explanation of error codes and their corresponding meanings for diagnosis.
A guide to identifying and resolving common operational problems.
General| Type | Inverter |
|---|---|
| Cooling Capacity | 28.0 kW |
| Heating Capacity | 31.5 kW |
| Refrigerant | R410A |
| Operating Temperature (Cooling) | -5°C to 48°C |
| Power Supply | 380-415V/3Ph/50Hz |
| Indoor Unit Noise Level | 45 dB(A) |
To Next Page
