Ultra Heat GMV5 User Manual
1
1 Safety Precautions
This is the safety alert symbol. It is used to alert you to potential personal injury hazards.
Obey all safety messages that follow this symbol to avoid possible injury or death.
This mark indicates procedures which, if improperly performed, might lead to the death or
serious injury of the user.
This mark indicates procedures which, if improperly performed, might possibly result in
personal harm to the user, or damage to property.
NOTICE is used to address practices not related to personal injury.
(1) Instructions for installation and use of this product are provided by the manufacturer.
(2) Installation must be performed in accordance with the requirements of NEC and CEC by authorized personnel
only.
(3) For operating the air conditioner pleasantly, install it as outlined in this installation manual.
(4) Connect the indoor unit and outdoor unit with the room air conditioner piping and cord available from our
standard parts. This installation manual describes the correct connections using the installation set available
from our standard parts.
(5) Before installation, check the power cord if it complies with the power supply requirement on the nameplate.
Make sure the power supply is safe.
(6) This air conditioner must be properly grounded through the receptacle to avoid electric shock. The ground wire
shouldn’t be connected with gas pipe, water pipe, lightning arrester or telephone line.
(7) If refrigerant leaks while work is being carried out, ventilate the area. If the refrigerant comes in contact with a
flame, it produces toxic gas.
(8) Do not power on until all installation work is complete.
(9) During installation, make sure that the refrigerant pipe is attached firmly before you run the compressor.
Do not operate the compressor under the condition of refrigerant piping not attached properly with gas pipe
and liquid pipe valve open.
This may cause abnormal pressure in the refrigeration cycle that leads to breakage and even injury.
(10) During the pump-down operation, make sure that the compressor is turned off before you remove the
refrigerant piping.
This may cause abnormal pressure in the refrigerant cycle that leads to breakage and even injury.
(11) When installing and relocating the air conditioner, do not mix gases other than the specified refrigerant
(R410A) to enter the refrigerant cycle.
(12) If air or other gas enters the refrigerant cycle, the pressure inside the cycle will rise to an abnormally high value
and cause breakage, injury, etc.
(13) This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
(14) Children should be supervised to ensure that they do not play with the appliance.
(15) If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
(16) When installing, specialized parts and accessories must be used. Otherwise, it may result in water leakage,
electric shock or fire hazard.
(17) Diameter of power cord must be large enough. Damaged power cord or connecting wire must be replaced by
specialized electric cable.
(18) After the power cord is connected, please install the cover of electric box to avoid danger
(19) Nitrogen must be charged according to technical requirements.
(20) For units with wired controllers, do not connect power supply until the wired controller is well installed.
Otherwise, the wired controller cannot be used.
To Next Page
Loading...
