Gree GMV-560WM/B-X - Page 336

GMV5 DC INVERTER VRF UNITS SERVICE MANUAL
333
Start
Self-diagnosis for approx. 1 sec. after switching on or after a Restart
Run
Normal processing of the user program after Start. Where a
programming unit is connected via a PCD8.K11x in PGU mode
(e.g. PG5 in PGU mode), the CPU automatically goes into the Stop
state and not the Run state; this is for safety reasons
Run
conditional
Conditional Run state. A condition has been set in the debugger
(Run until…), which has not yet been met
Run with error
Same as Run, but with an error message
Run cond. with
error
Same as conditional Run, but with an error message
Stop
The Stop state occurs in the following cases:
 Programming unit in PGU mode connected when the CPU was
switched on
 PGU stopped by programming unit
 Condition for a COND.RUN has been met
Stop with error
Same as Stop, but with an error message
Halt
The Halt state occurs in the following cases:
 Halt instruction processed
 Serious error in user program
 Hardware fault
 No program loaded
 no communication module on an S-Bus PGU or Gateway Master
port
System
diagnostics
If the PLC doesn‗t go to RUN after 2 minutes, you have to send it for
repair
Reset
The RESET state has the following causes:
 Supply voltage too low
 Firmware not starting up
4.3.3 PCD3.R600 Indicating LED