Gree GMV-60WL/C-T - Removal Operation for Blade

GREE DC Inverter Side Discharge VRF Ⅱ for North America
117
Removal operation for blade
Remark: Before removing the motor, please make sure that the unit is disconnected with the power.
Process
Photo
Operation Instruction
1. Remove grille
● Loose screws fixing the panel
with screwdriver
● Then remove the grille
2. Remove
blade
● Loosen nuts fixing the blade
with wrench
● Then remove the blade and put
it on the floor flatly
3. Remove
motor
● Loose screws fixing the motor
with screwdriver
● then remove the power cord of
motor
● Take out the damaged motor
4. Install motor
● Replace the motor, tighten
screws with screwdriver and then
connect the power cord of motor