MULTI VRF-Ⅱ INDOOR UNIT SERVICE MANUAL EUROPEAN/LATIN AMETICA (R410A)
45
panel.
(3) When the light of display panel is turned off, press the other buttons other than “Light” button, the
light on display panel will be turned off after 5 seconds.
4.2.4 Temperature Setting
Press “▼”or“▲” buttons under power-on status, the set temperature will be increased or decreased
at 1
℃
each time; when long press the buttons, the temperature will be increased or decreased at 1
℃
every 0.3 seconds. The temperature setting range is: 16
℃
～
30
℃
.
Notes:
Under auto mode, the temperature cannot be set through pressing “▼”or“▲” buttons.
4.2.5 Function Setting
Press “Function” button under power-on or power-off status, it can enter into function setting status.
Under function setting status, press “ON/OFF” button or without pressing any buttons for consecutive 5
seconds, it will quit the function setting status.
(1) Up and down swing function settings
Press “Function” button under power-on status to switch to up and down swing function, when “ ”
icon flickers, press “▲”or“▼” button to start up or cancel the up and down swing function. If “ ” is on it
means the function has been started up; if “ ” icon is off it means the function has been canceled.
(2) Left and right swing function settings
Press “Function” button under power-on status to switch to left and right swing function, when “ ”
flickers, press “▲”or“▼” button to start up or cancel the left and right swing function. If “ ” icon is on it
means the function has been started up; if “ ” icon is off it means the function has been canceled.
(3) Settings of X-fan
X-fan function: after closing down the unit under cooling and dry mode, the air conditioner will
automatically dry the water of evaporator of indoor unit to prevent breeding of bacteria and mildew.
Turn on or cancel X-fan function: with the unit is started up, under cooling or dry mode, press
“Function” button to switch to X-fan function, when “ ” flickers, press “▲”or“▼” buttons to start or cancel
X-fan function. If “ ” icon is on it means the X-fan function has been started up, if “ ” icon is off it
means the X-fan function has been canceled.
(4) Settings of Timer Function
Timer Function: under power-on status, the count down of power-off time can be set. Under power-
off status, the count down of power-on time can be set.
Timer setting: press “function” button to switch to timer function, when “ ” icon flichers, press
“▲”or“▼” button to adjust the setting time. After setting the time, press “ON/OFF” button or without
pressing any buttons for consecutive 5 seconds, the setting time is confirmed and quit the function setting
status. After quiting the function setting status, the “ ” icon is on, it means the timer function has been
turned on.
Cancel timer: press “Function” button to switch to timer function, when “ ” icon flickers, press
“▲”or“▼” button to set the time to be “00”, then the timer function is canceled; press “ON/OFF” button or
without pressing any buttons for consecutive 5 seconds, it will quit the function setting status. After quiting
To Next Page
Loading...
