Multi VRF Floor Standing Indoor Unit
20
closedown of timer function. Each time press “▲” or “▼” button, if
it is within 10 hours, it will increase or decrease 0.5 hour each time,
if long press “▲” or “▼” button, it will increase or decrease 0.5
hour every 0.3 seconds; if it is over 10 hours, each time press “▲”
or “▼” button will increase or decrease 1 hour each time, and if
long press “▲” or “▼” button, it will increase or decrease 1 hour
every 0.3 seconds.
(5) Setting of air renewal function.
1) Air renewal function: through adjusting the fresh air volume to
improve the air quality and keep the indoor fresh air.
2) Air renewal setting: press “Function” button to switch to air renewal
function, when “
” icon flickers, press “▲” or “▼” button to adjust
the air renewal level; after setting air renewal level, press
“ON/OFF” button or without pressing any buttons for consecutive 5
seconds, the air renewal function has been confirmed to be turned
on and then quit the function setting status. After quitting the
function setting status, the “
” icon is on, it means the air renewal
function has been turned on.
3) Cancel air renewal: press “Function” button to switch to air renewal
function, when “
” icon flickers, press “▲” or “▼” button to set the
air renewal as “00”, then the air renewal function is canceled;
press “ON/OFF” button or without pressing any buttons for
consecutive 5 seconds, it will quit the function setting status. After
quitting function setting status, the “
” icon is off, it means the air
renewal function is canceled.
4) Adjustment range of air renewal level: it can adjust the air renewal
level to be 00~10, in which “00” refers to closing down air renewal
function.
(6) Setting of Sleeping Function.
1) Sleeping function: set the unit to enter into sleeping operational
status, the unit will operate according to the preset sleeping
To Next Page
Loading...
