To Next PageTo Next PageHow to improve the cooling effect of my Gree Air Conditioner?
To improve the cooling effect of your Gree Air Conditioner, try the following: * Clean the filter. * Reduce the heat load of the room. * Close any doors or windows. * Unblock the inlet and outlet of the indoor unit. * Lower the setting temperature. * Check the performance of the room temperature sensor.
How to improve the heating effect of my Gree GMV-ND160ZD/A-T?
To improve the heating effect of your Gree Air Conditioner, consider the following: 1. Clean the filter. 2. Close the door or window. 3. Increase the setting temperature. 4. Check for refrigerant leakage. 5. Check if the outdoor ambient temperature is lower than -5°C. 6. Check for abnormality of the control circuit.
Why indoor fan doesn't start up during heating in my Gree GMV-ND160ZD/A-T Air Conditioner?
If the indoor fan of your Gree Air Conditioner doesn’t start up during heating, you can try the following: * Adjust the placing position of the tube temperature sensor head. * Ensure the tube temperature sensor head is inserted well. * Check if the wiring of the tube temperature sensor head is broken. * Check if the capacitor is leaking electricity.
General| Model | GMV-ND160ZD/A-T |
|---|---|
| Cooling Capacity | 16.0 kW |
| Heating Capacity | 18.0 kW |
| Refrigerant | R410A |
| Type | VRF |
| Power Supply | 380-415V/3Ph/50Hz |
Welcome and general instructions for users.
Manufacturer's disclaimer regarding responsibilities for product issues.
Critical safety warnings and precautions for unit operation and maintenance.
Overview of the product, its key components, and working conditions.
Details on required fittings, position selection, and wire specifications.
Step-by-step guide for installing the indoor unit, including suspension and leveling.
Procedures for connecting refrigerant and drainage pipes.
How to verify the proper functioning of the installed drainage system.
Guidance on installing the optional wired controller.
Instructions for connecting various wires to terminals and patch boards.
Steps for connecting power cords and communication wires for units and controllers.
Diagrams and instructions for wiring networks of controllers and indoor units.
Procedures for cleaning filters and seasonal maintenance tasks.
A table listing error codes and their corresponding descriptions for indoor unit issues.
Solutions for common problems like startup failures, performance issues, and fan operation.
