Gree GMV-ND22G/A3A-T - Page 11

Multi Variable Air Conditioners Wall Mounted Type Indoor Unit
7
Model Power Cord Size
Air Switch
apacity
(A)
Minimum
Sectional
Area of
Ground
Wire(mm
2
)
Minimum
Sectional Area
of Power
Cord(mm
2
)
GMV-N56G/A3A-K, GMV-N56G/A2A-K
GMV-N56G/A4A-K, GMV-N56G/A8A-K
GMV-N56G/C9A-K, GMV-N56G/E3A-K
220-240V ~ 50Hz 6 1 1
GMV-N63G/A3A-K, GMV-N63G/A2A-K
GMV-N63G/A4A-K, GMV-N63G/A8A-K
GMV-N63G/C9A-K, GMV-N63G/E3A-K
220-240V ~ 50Hz 6 1 1
GMV-N71G/A3A-K, GMV-N71G/A2A-K
GMV-N71G/A4A-K, GMV-N71G/A8A-K
GMV-N71G/C9A-K, GMV-N71G/E3A-K
220-240V ~ 50Hz 6 1 1
GMV-N22G/A3A-D, GMV-N22G/A8A-D
GMV-N22G/E3A-D, GMV-N22G/B3A-D
208-230V ~ 60Hz 6 1 1
GMV-N28G/A3A-D, GMV-N28G/A8A-D
GMV-N28G/E3A-D, GMV-N28G/B3A-D
208-230V ~ 60Hz 6 1 1
GMV-N36G/A3A-D, GMV-N36G/A8A-D
GMV-N36G/E3A-D, GMV-N36G/B3A-D
208-230V ~ 60Hz 6 1 1
GMV-N45G/A3A-D, GMV-N45G/A8A-D
GMV-N45G/E3A-D, GMV-N45G/B3A-D
208-230V ~ 60Hz 6 1 1
GMV-N50G/A3A-D, GMV-N50G/A8A-D
GMV-N50G/E3A-D, GMV-N50G/B3A-D
208-230V ~ 60Hz 6 1 1
GMV-N56G/A3A-D, GMV-N56G/A8A-D
GMV-N56G/E3A-D, GMV-N56G/B3A-D
208-230V ~ 60Hz 6 1 1
GMV-N63G/A3A-D, GMV-N63G/A8A-D
GMV-N63G/E3A-D, GMV-N63G/B3A-D
208-230V ~ 60Hz 6 1 1
GMV-N71G/A3A-D, GMV-N71G/A8A-D
GMV-N71G/E3A-D, GMV-N71G/B3A-D
208-230V ~ 60Hz 6 1 1
GMV-ND22G/A3A-T,GMV-ND28G/A3A-T
GMV-ND36G/A3A-T,GMV-ND45G/A3A-T
GMV-ND50G/A3A-T,GMV-ND56G/A3A-T
GMV-ND63G/A3A-T,GMV-ND71G/A3A-T
GMV-ND80G/A3A-T, MV-ND90G/A3A-T
GMV-ND100G/A3A-T
220-240V ~ 50Hz 6 1 1
GMV-ND22G/A8A-T,GMV-ND28G/A8A-T
GMV-ND36G/A8A-T,GMV-ND45G/A8A-T
GMV-ND50G/A8A-T,GMV-ND56G/A8A-T
GMV-ND63G/A8A-T,GMV-ND71G/A8A-T
GMV-ND80G/A8A-T,GMV-ND90G/A8A-T
GMV-ND100G/A8A-T
220-240V ~ 50Hz 6 1 1
Notes:
① Use copper wire only as unit’s power cord. Operating temperature should be within its rated
value.
② If the power cord is more than 15m long, please increase properly the sectional area of
power cord to avoid overload, which may cause accident.
③ Above selection requirements: Power cord size is based on BV single-core wire (2~4pc) at
40°Cambient temperature when laying across plastic pipe. Air switch is D type and used at
40°C. If actual installation condition varies, please lower the capacity appropriately
according to the specifications of power cord and air switch provided by manufacturer.
④ If the supply cord is damaged, it must be replaced by the manufacturer or its service agent
or a similarly qualified person in order to avoid a hazard.
⑤ Install cut-off device near the unit. The minimum distance between each stage of cut-off
device should be 3mm(The same for both indoor unit and outdoor unit).