CONTROL PANEL
Note: If the remote controller is missing, operate on the control panel.
1
ON/OFF button
Operation starts when pressing this button, and
stops when pressing this button again.
2
SWING button
Activate the automatic air swing function.
3
FAN SPEED button
Select the fan speed LOW, MED, HIGH and TURBO
in sequence.
6
FILTER CHECK button
This feature is a reminder of cleaning the air
filter(normal maintenance) for more efficient
operation. The light will turn on automatically
after the fan works more than 250 hours.
If the light is on, turn off and power off the
unit, take the air filter out and clean it, then
re-install the air filter, power on and turn
on the unit, the light will still be on, press
FILTER CHECK button,the light will
turn off.
4
(+/-) / TIMER button
Press the + button to increase the set(operating)
temperature of the unit,and press the - button to
decrease the set(operating) temperature of the
unit. the temperature setting range is from 16~30℃
Press TIMER button,then press +/- to increase
and decrease the time setting.If the time setting
is no more than 10 hours,the increment/decrement
is 0.5 hour by each press,if more than 10 hours,
the increment/decrement is 1 hour by each press.
The time setting range is 0.5~24 hours.
o
(61~86 F).
- 13 -
5
MODE button
Select the operation mode, COOL, DRY,
FAN, HEAT (for heat pump model) or
COOL, DRY, FAN (for cooling only model).
3 46
2
1
4
5
Not available for
cooling only model
TURBO
HIGH
MED
LOW
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
To Next Page
Loading...
