Heat Pump Pool Heater
3
(1) Please install according to the instructions. The installation work must be carried out by
professional installation personnel.
(2) Any person who is involved with working on or breaking into a refrigerant circuit should hold a
current valid certificate from an industry-accredited assessment authority, which authorizes
their competence to handle refrigerants safely in accordance with an industry recognized
assessment specification.
(3) Servicing shall only be performed as recommended by the equipment manufacturer.
Maintenance and repair requiring the assistance of other skilled personnel shall be carried out
under the supervision of the person competent in the use of flammable refrigerants.
(4) Please cut off the power supply during maintenance.
(5) The appliance shall be installed in accordance with national wiring regulations.
(6) The fixed wires connecting to the appliance must be configured with all-pole disconnection
device under voltage grade III according to wiring rules.
(7) The unit should be stored with protective measures against mechanical damage caused by
accident.
(8) It is forbidden to stand or place articles on the unit.
(9) If the installation space for unit pipe is too small, adopt a protective measure to prevent the
pipe from physical damage.
(10) During installation, use the specialized accessories and components, otherwise water
leakage, electric shock or fire hazard may occur.
(11) Please install the unit in a secure place that can withstand the weight of unit. Insecure
installation may cause the unit falling down and lead to injury.
(12) Be sure to adopt independent power circuit. If the power cord is damaged, it must be repaired
by the manufacturer, service agent or other professional agents.
(13) The unit can be cleaned only after it is turned off and power-disconnected, otherwise electric
shock may occur.
(14) The unit is not intended to be cleaned or maintained by children without supervision.
(15) Do not alter the setting of pressure sensor or other protective devices. If the protective
devices are short-circuited or changed against rules, fire hazard or even explosion may occur.
(16) Do not operate the unit with wet hands. Do not wash or sprinkle water on the unit, otherwise
malfunction or electric shock will occur.
(17) If the unit is to be installed in a small space, please adopt protective measures to prevent the
concentration of refrigerant from exceeding the allowable safety limit; Excessive refrigerant
leakage may lead to explosion.
(18) When installing or re-installing the unit, please keep the refrigerant circuit away from
substances other than the specified refrigerant, such as air. Any presence of foreign
substances will cause abnormal pressure change or even explosion, resulting in injury.
(19) Only professionals are allowed to carry on daily maintenance.
(20) Before contacting any wire, make sure power is cut off.
(21) Do not let any inflammable objects near the unit.
(22) Do not use organic solvent to clean the unit.
(23) If you need to replace a component, please ask a professional to repair with a component
supplied by the original manufacturer so as to ensure the unit’s quality.
To Next Page
Loading...