Gree GUD140T/A-T - Piping Position; Swing Flap Motor

DC Inverter U-match Series Cassette Type Unit
35
(1) Temporarily hang the 4 fasteners on the corresponding hooks of the main body
of the indoor unit (Do not let the conducting wires get involved into the sealing
material).
(2) Screw in the hexagon screws beneath the 4 fasteners by about 15mm (front
panel will rise).
(3) As shown below, turn the front panel according to the arrow direction so that the
front panel can be well connected with the ceiling.
(4) Screw up the screws until the thickness of the sealing material between the
front panel and the ceiling is 5-8mm.
5~8mm(1/4~3/8inch)
Latch
Piping position
Hook
Swing flap motor
Indoor unit
Ceiling
Air outlet
Panel
Indoor unit
①
②
②
③
④
⑤
Notice
(1) Improper screw looseness will lead to the following problem.
Gas leakage of
ceiling
Condensate Water drops
Gas leakage
(2) After the screws are tightened, if there is still a gap between the ceiling and the