GREE DC INVERTER HEAT PUMP CONDENSING UNIT SERVICE MANUAL
93
Removal of Fan and Motor
NOTE: Before removing the fan, make sure power is cut off.
Step Picture Work Instruction
4. Install the motor.
Replace with a new
motor. Then tighten up
the screw bolt.
5. Install the fan.
Install the fan in place.
Put on the gasket and
use a wrench to secure
the screw nut.
NOTE: After installing the
fan, turn the fan by hand
to see if it can run
normally. If not, please
check for the reason.
6. Install the grill.
After replacing the motor,
use a screwdriver to
tighten up the screw bolt
that secures the motor.
Arrange the wires
according to the wiring
diagram.
To Next Page
Loading...
