GREE U-Match 5 SERIES UNIT SERVICE MANUAL
112
Removal of electronic expansion valve
Note: Before removing the electronic expansion valve, make sure there is no refrigerant in the pipeline and power is cut off.
2. Remove the electric
box.
●The connection wires inside and
outside the electric box should be
removed.
●When removing the electric box,
be careful to protect the
components.
3. Remove the electronic
expansion valve.
●Take off the coil of electronic
expansion valve.
●Loosen the connection pipe of
electronic expansion valve by
welding. Then remove the
connection pipe.
Note: When welding the pipe, do
not let the flame bunt the other
components.
4. Take out the electronic
expansion valve.
●Take out the electronic expansion
valve.
To Next Page
Loading...
Need help?
General
