Gree GUD50T/A-T - Page 97

GREE U-Match 5 SERIES UNIT SERVICE MANUAL
92
Removal of front panel
Note: Before removing the front panel, make sure power is cut off.
Step
Picture
Work instruction
9. Install the front side plate.
●Fix the clasps on both sides of
the plate and tighten up the
screws.
10. Install the upper cover plate.
●Tighten up the screws around
the upper cover plate.
Model: GUD100W/NhA-T, GUD125W/NhA-T, GUD140W/NhA-T,
GUD100W/NhA-X, GUD125W/NhA-X, GUD140W/NhA-X
Removal of compressor/gas liquid separator
Note: Before removing the compressor/gas liquid separator, make sure there is no refrigerant in the pipeline and power is cut off.
Step
Picture
Work instruction
1． Remove wires.
●Loosen the securing screws of
the wires with a screwdriver.
●Remove the wires.
Note: When removing the wires,
mark the wire terminals
corresponding to their color so as
to avoid misconnection.