GREE U-Match 5 SERIES UNIT SERVICE MANUAL
93
Removal of compressor/gas liquid separator
Note: Before removing the compressor/gas liquid separator, make sure there is no refrigerant in the pipeline and power is cut off.
2 Break off the pipes that
connecting to the compressor/gas
liquid separator.
●Weld the pipes that are
connected to the compressor/gas
liquid separator.
●Then remove the pipes.
Note: When welding the pipes, do
not let the flame burn the other
components.
3． Loosen the compressor‘s base
connectors / gas liquid separator‘s
base nuts.
●Use a wrench to twist off the
compressor/gas liquid
separator‘s base nuts.
4．Remove the compressor/gas
liquid separator from the chassis.
●Take away the compressor/gas
liquid separator and replace with
a new one.
Note: When replacing the
compressor/gas liquid separator,
avoid touching the nearby
pipeline and components.
To Next Page
Loading...