GREE U-Match 5 SERIES UNIT SERVICE MANUAL
94
Removal of compressor/gas liquid separator
Note: Before removing the compressor/gas liquid separator, make sure there is no refrigerant in the pipeline and power is cut off.
5． Install the new compressor/gas
liquid separator onto the chassis.
●After replacing the
compressor/gas liquid separator,
tighten up the base screw nuts.
6．Connect the welding interfaces
of compressor/gas liquid separator
to the pipeline.
●Weld the connection pipes of
compressor so as to connect
them to the compressor.
Note: When replacing the
compressor, avoid touching the
nearby pipeline and components.
7． Connect the compressor wires.
●Connect the compressor wires
to the wire terminals on the top of
compressor.
Note: When connecting the
wires, be sure to match the colors
with the corresponding wire
terminals.
To Next Page
Loading...