GREE U-Match 6 SERIES UNIT SERVICE MANUAL
110
Removal of fan and motor
Note: Before removing the fan, make sure power is cut off.
Step Picture Work instruction
2. Remove the fan.
Use a wrench to remove
the specialized nut and
gasket of the fan.
Note: Please keep the nut
and gasket safe after
removing them from the
fan.
3. Remove motor.
Use a screwdriver to
unscrew the bolt of motor.
Note: Motor wire should be
first removed from the
electric box.
4. Install the motor.
Replace with a new motor.
Then tighten up the screw
bolt.
5. Install the fan.
Install the fan in place. Put
on the gasket and use a
wrench to secure the
screw nut.
Note: After installing the
fan, turn the fan by hand to
see if it can run normally. If
not, please check for the
reason.
To Next Page
Loading...
