GREE U-Match 6 SERIES UNIT SERVICE MANUAL
111
Removal of fan and motor
Note: Before removing the fan, make sure power is cut off.
Step Picture Work instruction
6. Install the grill.
After replacing the motor,
use a screwdriver to
tighten up the screw bolt
that secures the motor.
Model: GUD100W1/NhA-S,GUD125W1/NhA-S
Removal of condenser
Note: Before removing the condenser, make sure there is no refrigerant in the pipeline and power is cut off.
Step Picture Work instruction
1. Remove the panels.
Remove the upper, lower
and front panels.
2. Remove the electric box.
Loosen the wire clamp at
the bottom of the electric
box.
Unscrew the screws of
electric box.
The connection wires inside
and outside the electric box
should be removed.
To Next Page
Loading...
