GREE U-Match 6 SERIES UNIT SERVICE MANUAL
117
Removal of compressor
Note: Before removing the compressor, make sure there is no refrigerant in the pipeline and power is cut off.
Step Picture Work instruction
3. Break off the pipes that
connecting to the
compressor.
Weld the pipes that are
connected to the
compressor.
Then remove the pipes.
Note: When welding the
pipes, do not let the
flame burn the other
components.
4. Remove the compressor
from the chassis.
Take out the
compressor and
replace it.
Note: When replacing
the compressor, avoid
touching the nearby
pipeline and
components.
5. Fix the new compressor
back onto the chassis.
After replacing the
compressor, tighten up
the screws at the foot of
compressor.
To Next Page
Loading...
