Gree GUD71PHS1/A-S - Page 129

GREE U-Match 6 SERIES UNIT SERVICE MANUAL
126
Removal of electronic expansion valve
Note: Before removing the electronic expansion valve, make sure there is no refrigerant in the pipeline and power is cut off.
Step Picture Work instruction
7. Check and install the
panels.
 Check whether each
component and
connection wire is well
connected.
 If everything is OK, install
the upper, left and right
panels. Tighten up the
screws.
Model: GUD140W1/NhA-X
Removal of compressor
Note: Before removing the compressor, make sure there is no refrigerant in the pipeline and power is cut off.
Step Picture Work instruction
1. Remove the panels and
wires.
 Remove the upper, lower
and front panels.
 Loosen the securing
screws of the wires with a
screwdriver.
 Remove the wires.
Note: When removing the
wires, mark the wire
terminals corresponding
to their color so as to
avoid misconnection.
2. Loosen the securing
screws at the foot of
compressor.
 Use a wrench to twist off
the screws at the foot of
compressor.