GREE U-Match 6 SERIES UNIT SERVICE MANUAL
127
Removal of compressor
Note: Before removing the compressor, make sure there is no refrigerant in the pipeline and power is cut off.
Step Picture Work instruction
3. Break off the pipes that
connecting to the
compressor.
Weld the pipes that are
connected to the
compressor.
Then remove the pipes.
Note: When welding the
pipes, do not let the flame
burn the other
components.
4. Remove the compressor
from the chassis.
Take out the compressor
and replace it.
Note: When replacing the
compressor, avoid
touching the nearby
pipeline and components.
5. Fix the new compressor
back onto the chassis.
After replacing the
compressor, tighten up
the screws at the foot of
compressor.
To Next Page
Loading...
