GREE U-Match 6 SERIES UNIT SERVICE MANUAL
131
Removal of fan and motor
Note: Before removing the fan, make sure power is cut off.
Step Picture Work instruction
5. Install the fan.
Install the fan in place. Put
on the gasket and use a
wrench to secure the
screw nut.
Note: After installing the
fan, turn the fan by hand
to see if it can run
normally. If not, please
check for the reason.
6. Install the grill.
After replacing the motor,
use a screwdriver to
tighten up the screw bolt
that secures the motor.
Model: GUD140W1/NhA-X
Removal of compressor
Note: Before removing the compressor, make sure there is no refrigerant in the pipeline and power is cut off.
Step Picture Work instruction
1. Remove the panels and
wires.
Remove the upper, lower
and front panels.
Loosen the securing
screws of the wires with a
screwdriver.
Remove the wires.
Note: When removing the
wires, mark the wire
terminals corresponding
to their color so as to
avoid misconnection.
To Next Page
Loading...