GREE U-Match 6 SERIES UNIT SERVICE MANUAL
132
Removal of compressor
Note: Before removing the compressor, make sure there is no refrigerant in the pipeline and power is cut off.
Step Picture Work instruction
2. Loosen the securing
screws at the foot of
compressor.
Use a wrench to twist off
the screws at the foot of
compressor.
3. Break off the pipes that
connecting to the
compressor.
Weld the pipes that are
connected to the
compressor.
Then remove the pipes.
Note: When welding the
pipes, do not let the flame
burn the other
components.
4. Remove the compressor
from the chassis.
Take out the compressor
and replace it.
Note: When replacing the
compressor, avoid
touching the nearby
pipeline and components.
To Next Page
Loading...