GREE U-Match 6 SERIES UNIT SERVICE MANUAL
133
Removal of compressor
Note: Before removing the compressor, make sure there is no refrigerant in the pipeline and power is cut off.
Step Picture Work instruction
5. Fix the new compressor
back onto the chassis.
After replacing the
compressor, tighten up
the screws at the foot of
compressor.
6. Connect the compressor
suction port and exhause
port with the pipes.
Weld the compressor
connection pipes and
connect them to the
compressor.
Note: When replacing the
compressor, avoid
touching the nearby
pipeline and components.
7. Connect the compressor
wires.
Connect the compressor
wires to the wire terminals
on the top of compressor.
Note: When connecting
the wires, be sure to
match the colors with the
corresponding wire
terminals.
To Next Page
Loading...