Gree GUD71PHS1/A-S - Page 142

GREE U-Match 6 SERIES UNIT SERVICE MANUAL
139
Removal of fan and motor
Note: Before removing the motor, power must be cut off.
Step Picture Work instruction
8. Install the water tray and
electric box.
 Direct the 4 corners of water
tray to the 4 corners of the
unit and then press them.
Use a screwdriver to tighten
the screws in the 4 corners.
 Connect the power cord and
water pump wire.
 Place back the cover of
electric box and the clamp of
power cord. Then tighten the
screws with a screwdriver.
Take model GUD125T1/A-S as an example.
Removal of fan and motor
Note: Before removing the motor, power must be cut off.
Step Picture Work instruction
1. Remove the front panel.
 Turn off the power supply of
indoor unit.
 Push the 4 corner plates in
the directions shown by the
arrows.
 Loosen the screws and
remove the front panel.
2. Remove the cover of
electric box and the
clamp of power cord.
 Remove the motor wire and
water pump of the electric
box.