Gree GUD71PHS1/A-S - Page 145

GREE U-Match 6 SERIES UNIT SERVICE MANUAL
142
Removal of fan and motor
Note: Before removing the motor, power must be cut off.
Step Picture Work instruction
7. Install the fan.
 Direct the hole of fan to the
motor shaft and then mount
on the fan.
 Tighten the clamping band
of motor with a wrench.
8. Install the water tray
and electric box.
 Direct the 4 corners of water
tray to the 4 corners of the
unit and then press them.
Use a screwdriver to tighten
the screws in the 4 corners.
 Connect the power cord and
water pump wire.
 Place back the cover of
electric box and the clamp
of power cord. Then tighten
the screws with a
screwdriver.
4.5.2.2 Duct Type Unit
Take model GUD35PHS1/A-S as an example.
Removal of fan and motor
Note: Before removing the motor, make sure power is cut off.
Step Picture Work instruction
1. Remove the cover of
electric box.
 Turn off the power supply of
indoor unit. Use a screwdriver to
remove the cover of electric box.
Disconnect the motor wire inside
the electric box.
2. Remove air return
plate, the longitudinal
component and air
return frame.
 Use a hex wrench to loosen the
screws of fan.
 Order of removal: air return
plate, air return frame,
longitudinal component, cross
beam