Gree GUD71PHS1/A-S - Page 146

GREE U-Match 6 SERIES UNIT SERVICE MANUAL
143
Removal of fan and motor
Note: Before removing the motor, make sure power is cut off.
Step Picture Work instruction
3. Remove the upper
volute.
 Loosen the screws of upper
volute and then pull out the
upper volute.
4. Remove the lower
volute.
 Loosen the screws of lower
volute and then rotate in the
direction shown by the arrow.
5. Remove the motor
and fans.
 Use a screwdriver to remove the
clamping band of motor. Then
remove the motor and fan as a
whole.
6. Replace the motor.
 Remove the motor from the
motor support.
 Use a hex wrench to loosen the
screws of fan.
 Remove the fan from the motor.
 Replace with a new motor.
7. Re-install the device
in a reverse order of
the removal
procedure.
 Re-install the device in a reverse
order of the removal procedure.
Then connect power and test it.
Take model GUD71PHS1/A-S as an example:
Removal of fan and motor
Note: Before removing the motor, make sure power is cut off.
Step Picture Work instruction
1. Remove the cover
of electric box.
 Turn off the power supply of
indoor unit. Use a screwdriver
to remove the cover of electric
box. Disconnect the motor wire
inside the electric box.