GREE U-Match 6 SERIES UNIT SERVICE MANUAL
144
Removal of fan and motor
Note: Before removing the motor, make sure power is cut off.
Step Picture Work instruction
2. Remove air return
plate, the
longitudinal
component and air
return frame.
Use a hex wrench to loosen
the screws of fan.
Order of removal: air return
plate, air return frame,
longitudinal component, cross
beam
3. Remove the upper
volute.
Loosen the screws of upper
volute and then pull out the
upper volute.
4. Remove the lower
volute.
Loosen the screws of lower
volute and then rotate in the
direction shown by the arrow.
5. Remove the motor
and fans.
Use a screwdriver to remove
the clamping band of motor.
Then remove the motor and
fan as a whole.
To Next Page
Loading...