Gree GUD71PHS1/A-S - Page 148

GREE U-Match 6 SERIES UNIT SERVICE MANUAL
145
Removal of fan and motor
Note: Before removing the motor, make sure power is cut off.
Step Picture Work instruction
6. Replace the motor.
 Remove the motor from the
motor support.
 Use a hex wrench to loosen
the screws of fan.
 Remove the fan from the
motor.
 Replace with a new motor.
7. Re-install the
device in a reverse
order of the removal
procedure.
 Re-install the device in a
reverse order of the removal
procedure. Then connect
power and test it.
Take model GUD140PHS1/A-S as an example.
Removal of air return filter
Note: Before removal, make sure power is cut off. During the removal procedure, take good care of all the components. Do
not place the filter near any heat source.
Step Picture Work instruction
Remove air
return filter.
 Press the air return filters on the
guide way sponge. There are 2
or 3 air return filters.
Removal of the cover of electric box and the electric box
Note: Before removal, make sure power is cut off. During the removal procedure, take good care of all the components,
especially the electric components. Do not hit or beat.
Step Picture Work instruction
1. Remove the
cover of electric
box.
 Loosen the screws as shown
by the circle and the box.
Remove the box in the
direction shown by the arrow.