GREE U-Match 6 SERIES UNIT SERVICE MANUAL
146
Removal of the cover of electric box and the electric box
Note: Before removal, make sure power is cut off. During the removal procedure, take good care of all the components,
especially the electric components. Do not hit or beat.
Step Picture Work instruction
2. Remove the
electric box.
Loosen the securing screws
and remove the electric box.
Removal of water tray
Note: Before removal, make sure power is cut off. During the removal procedure, take good care of all the components.
Step Picture Work instruction
1. Remove the cover
plate.
Loosen the screws of cover
plate and then remove the
cover plate. (As shown in the
picture, the circle indicates 6
screws of the cover plate.)
2. Remove the water tray.
Loosen the screws of water
trap. Pull it up and remove it.
The removed water tray is as
shown in the picture.
Removal of evaporator
Note: Make sure power is cut off. Take good care of the copper pipe and aluminum fins. If the removal takes a long time,
please put the copper pipe under pressure.
Step Picture Work instruction
1. Remove the screws on
the side plate of
evaporator.
Remove the screws of
evaporator and the screws
that connect the upper cover
plate to the left and right side
plates.
To Next Page
Loading...