GREE U-Match 6 SERIES UNIT SERVICE MANUAL
147
Removal of evaporator
Note: Make sure power is cut off. Take good care of the copper pipe and aluminum fins. If the removal takes a long time,
please put the copper pipe under pressure.
Step Picture Work instruction
2. Remove the sealing
plate the connects to
the evaporator valve
and the screws that
connect to the flange.
Remove the screws of the
sealing plate of valve. Then
remove the sealing plate of
valve. Remove the screws
that connect the evaporator
to the flange.
3. Remove the
evaporator.
Take off the evaporator. The
removed evaporator is as
shown in the picture.
4.5.2.3 Floor Ceiling Unit
Take model GUD160ZD1/A-S as an example.
Removal of front grill
Note: Before removal, make su
re power is cut off. During the removal procedure, take good care of all the components. Do
not place the filter near any heat source.
Step Picture Work instruction
Remove the
sub-assembly of
front grill.
Twist off the 2 hooks of the
grill and the screws of the
hooks.
Open the grill and remove 2
lower clamps. Then remove
the grill.
Remove the right and left decorative boards
Note: Before removal, make sure power is cut off. During the removal procedure, take good care of all the components. Do
not scratch the appearance components.
Step Picture Work instruction
Remove the left and
right panels.
Use a screwdriver to loosen
the screws, as shown in the
picture. Then pull the right
and left panels upward.
(Lines in the picture indicate
the positions of screws.)
To Next Page
Loading...