GREE U-Match 6 SERIES UNIT SERVICE MANUAL
148
Removal of electric box assembly
Note: Before removal, make sure power is cut off. During the removal procedure, take good care of all the components,
especially the components in electric box. Protect it from water and collision.
Step Picture Work instruction
Remove the electric
box.
Unscrew 34 screws as shown in
the left picture and then remove
the electric box.
Removal of air guide louver
Note: Before removal, make sure power is cut off. During the removal procedure, take goo
d care of all the components,
especially the connectors of air guide louver.
Step Picture Work instruction
Remove the air
guide louver
assembly.
Remove the air guide louver
from its supporting assembly.
Then take off the connectors
from the swing motor. (As shown
in the picture, the lines indicate
the supporting assembly.)
Removal of water tray
Note: Before removal, make sure power is cut off. During the removal procedure, take good care of all the components.
Step Picture Work instruction
Remove the water
tray.
Remove the water tray.
To Next Page
Loading...