Gree GUD71PHS1/A-S

GREE U-Match 6 SERIES UNIT SERVICE MANUAL
149
Removal of evaporator
Note: Make sure power is cut off. Take good care of the copper pipe and aluminum fins. If the removal takes a long time,
seal the copper pipe.
Step Picture Work instruction
Remove the evaporator
assembly.
 Twist off the 6 screws of
the evaporator, 3 screws
of the plate board of water
releasing flume, and 2
screws of the water tray.
Then remove the
evaporator.
Removal of display panel and fan assembly
Note: Before removal, make sure power is cut off. During the removal procedure, take good care of all the components.
Step Picture Work instruction
Remove the display
panel and fan assembly.
 First remove the display
panel, next the bracket
and then the swing motor
mounting plate.
Removal of fan and motor
Note: Before removal, make sure power is cut off. During the removal procedure, take good care of all the components,
especially the screws of fan.
Step Picture Work instruction
1. Remove the volutes.
 Press the retaining ring at
the joint of front and rear
volutes. Then pull up the
front volute. Then loosen
the screws of the rear
volute. Lift up the retaining
ring of the rear volute and
take it off. (As shown in
the picture, the lines
indicate the screws on
both sides of the volutes.
2. Remove the fan.
 Loosen the 2 screws of
the coupler. Take out the
shaft and axial flow fan.
Loosen the screws of axial
flow fan and remove the
axial flow fan.