GREE U-Match 5 SERIES UNIT SERVICE MANUAL
109
Removal of compressor
Note: Before removing the compressor, make sure there is no refrigerant in the pipeline and power is cut off.
Step Picture Work instruction
2. Loosen the securing screws
at the foot of compressor.
Use a wrench to twist off the
screws at the foot of
compressor.
3. Break off the pipes that
connecting to the compressor.
Weld the pipes that are
connected to the
compressor.
Then remove the pipes.
Note: When welding the
pipes, do not let the flame
burn the other components.
4. Remove the compressor from
the chassis.
Take out the compressor and
replace it.
Note: When replacing the
compressor, avoid touching
the nearby pipeline and
components.
5. Fix the new compressor back
onto the chassis.
After replacing the
compressor, tighten up the
screws at the foot of
compressor.
To Next Page
Loading...
