Function and Control
ƾ
●
●
●
●
●
When replacing the batteries, do not use old or different types of batteries,otheerwise,
If the remote controller will not be used for a long time, please
it may cause malfunction.
remove batteries
to prevent batteries from leaking.
The operation should be performed in its receiving range.
It should be kept 1m away from the TV set or stereo sound sets.
If the remote controller does not operate normally, please take the
batteries out
and replace them after 30 seconds.If still not operating properly,
Notes:
replace the batteries.
Sketch map for
replacing batteries
18
19
SLEEP:
LIGHT:
16
17
Press this button, Sleep On and Sleep Off can be selected. After Sleep function set up, the unit will automatically select
the suitable operation mode to maintain the most comfortable temperature for you. This function is available in COOL ,
HEAT or DRY mode
TURBO:
15
Press this button to activate / deactivate the Turbo function which enables the unit to reach the preset temperature in
shortest time. Such as in COOL mode, the unit will blow strong cooling air at super high fan speed. In HEAT mode, the
unit will blow strong heating air at super high fan speed.
(This function is not applicable for some models)
Press this button to select LIGHT on or off in the displayer. When the LIGHT on is set,the icon will be displayed and
the indicator light in the displayer will be on. When the LIGHT off is set, the icon will be displayed and the indicator
light in thedisplayer will be off.
"+" and "–"button about lock:
Press "+ " and "-" buttons simultaneously to lock or unlock the keypad. If the remote controller is locked, is displayed .
In this case, pressing any button , blinks three times.
"MODE" and " - " buttons About switch between fahrenheit and celsius:
At unit OFF, press "MODE" and " - " buttons simultaneously to switch between ℉ and ℃.
1．Slightly to press the place with , along the arrowhead direction to push the back
cover of wireless remote control. (As show in figure)
2. Take out the old batteries. (As show in figure)
3. Insert two new AAA1.5V dry batteries, and pay attention to the polarity.
(As show in figure)
4 .Attach the back cover of wireless remote control. (As show in figure)
TIMER OFF ：
14
13
TEMP :
Once press this key to enter into TIMER OFF setup, in which case the TIMER OFF icon will blink.The method of setting
is the same as TIMER ON.
Press this button, could select displaying (the indoor setting temperature) , (indoor ambient temperature )or (
outdoor am-bient temperature) .The unit defaults not to display the icon. During operation of TEMP button, the set tem-
perature is always displayed
6.2 Changing batteries and notices
17
To Next Page
Loading...
