65
Installation and Maintenance
Service Manual
Terminals
screws
Step Procedure
Remove the screw xing the left and right drive
motor; disconnect the wiring terminal in the motor
and then remove the drive motor
5. Remove electric box assy
Remove the screw fixing electric box 3
,
Remove
the electric box 3.
①
Cut off the wire binder and pull out the
indoor tube temperature sensor.
②
Screw off two grounding screw.
③
Remove the room temperature sensor.
Remove the wiring terminals of motor, left&right
swing motor, up&down swing motor and out-
pushing mechanism motor
Wire binder
Grounding
screw
Indoor tube
temperature sensor
Room temperature
sensor
Wiring terminal
of motor
Terminal of left&right
swing motor
Terminals of up&down swing motor
and out-pushing mechanism motor
Terminals
screws
screw
Electric
Box 3
To Next Page
Loading...
