66
Installation and Maintenance
Service Manual
Step Procedure
Remove the screw xing electric box assy, Remove
the electric box assy.
6. Remove rear case assy
Separately remove the screws fixing the left
side plate, right side plate and mice-prevention
board, and then remove them. Loosen the clasp
of connection pipe clamp and then remove the
connection pipe clamp.
Remove the screw xing the evaporator; push the
motor clamp rightwards to separate the clasp in
motor clamp; slightly adjust the evaporator inlet and
outlet pipe, and then lift the evaporator upwards to
remove it.
Screws
Screw
Screws
clasps
Left Side
Plate
Right Side Plate
Mouseproof Board
Connecting pipe clamp
To Next Page
Loading...
