Gree GWH12RB-K3DNA5G - Page 61


,QVWDOODWLRQDQG0DLQWHQDQFH
6HUYLFH0DQXDO
5HPRYDO3URFHGXUH
5HPRYDO3URFHGXUHRI,QGRRU8QLW
:DUQLQJ%HVXUHWRZDLWIRUDPLQLPXPRIPLQXWHV
DIWHUWXUQLQJRIIDOOSRZHUVXSSOLHVDQGGLVFKDUJHWKH
UHIULJHUDQWFRPSOHWHO\EHIRUHUHPRYDO
ProcedureSteps
a
b
panel
clasp
left filter and right filer
1. Remove filter
Open the panel.
Loosen the clasp shown in the fig and then pull
the left filter and right filer outwards to remove
them.
2. Remove horizontal louver
Push out the axile bush on horizontal louver.
Bend the horizontal louver with hand and then
separate the horizontal louver from the
crankshaft of step motor to remove it.
location of step motor
horizontal louver
axile bush