55
Technical Information
Service Manual
is set. Do not put the remote controller near the object of high
temperature or low temperature in order to avoid detecting
inaccurate ambient temperature. When I FEEL function is turned
on, the remote controller should be put within the area where
indoor unit can receive the signal sent by the remote controller.
Sleep function
Press "Clock" and "Light" buttons simultaneously, can select
Sleep 1 ( ), Sleep 2 ( ), Sleep 3 ( ) and cancel the
Sleep, circulate between these, after electried, Sleep Cancel is
defaulted.
● Sleep 1 is Sleep mode 1, in Cool modes: sleep status after run
for one hour, the main unit setting temperature will increase 1,
two hours, setting temperature increased 2, then the unit will run
at this setting temperature; In Heat mode: sleep status after run
for one hour, the setting temperature will decrease 1, two hours,
setting temperature will decrease 2, then the unit will run at this
setting temperature.
● Sleep 2 is sleep mode 2, that is air conditioner will run according
to the presetting a group of sleep temperature curve.
● Sleep 3 the sleep curve setting under Sleep mode by DIY;
(1) Under Sleep 3 mode, press "Health" button for a long time,
remote controller enters into user individuation sleep setting
status, at this time, the time of remote controller will display
"1HOUR", the setting temperature "88" will display the
corresponding temperature of last setting sleep curve and
blink (The first entering will display according to the initial
curve setting value of original factory);
(2) Adjust " + " and " - " button, could change the corresponding
setting temperature, after adjusted, press "Health" button for
conrmation;
(3) At this time, 1hour will be automatically increased at the
timer position on the remote control, (that are "2HOUR" or
"3HOUR" or "8HOUR"), the place of setting temperature
"88" will display the corresponding temperature of last
setting sleep curve and blink;
(4) Repeat the above step (2)~(3) operation, until 8 hours
temperature setting nished, sleep, curve setting nished, at
this time, the remote controller will resume the original timer
display; temperature display will resume to original setting
temperature.
● Sleep 3 the sleep curve setting under Sleep mode by DIY could
be inquired:
The user could accord to sleep curve setting method to inquire the
presetting sleep curve, enter into user individuation sleep setting
status, but do not change the temperature, press "Health" button
directly for conrmation. Note: In the above presetting or enquiry
procedure, if continuously within 10s, there is no button pressed,
the sleep curve setting within 10s, there is no button pressed, the
sleep curve setting status will be automatically quit and resume
to display the original displaying. In the presetting or enquiry
procedure, press " On/Off " button, "Mode" button, "Clock" and
"Light" buttons simultaneously, the sleep curve setting or enquiry
status will quit similarly.
Replacement of batteries in remote controller
reinstall
battery
Cover of battery box
remove
1. Press the back side of remote controller marked with " ", as
shown in the g, and then push out the cover of battery box along
the arrow direction.
2. Replace two 7# (AAA 1.5V) dry batteries, and make sure the
position of " + " polar and " - " polar are correct.
3. Reinstall the cover of battery box.
NOTE:
● During operation, point the remote control signal sender at the
receiving window on indoor unit.
● The distance between signal sender and receiving window
should be no more than 8m, and there should be no obstacles
between them.
● Signal may be interfered easily in the room where there is
uorescent lamp or wireless telephone; remote controller should
be close to indoor unit during operation.
● Replace new batteries of the same model when replacement is
required.
● When you don't use remote controller for a long time, please
take out the batteries.
● If the display on remote controller is fuzzy or there’s no display,
please replace batteries.
To Next Page
Loading...
