Gree GWH18ND-K3NNA4A - Page 79

5HPRYDO3URFHGXUH

Stepping Motor
1
10. Remove motor and axial flow blade
Twist off the screws on stepping motor
with screwdriver and then remove the
stepping motor.
Motor press plate
O-Gasket
sub-assy of
Bearing
Ring of
Bearing
2
3
4
5
Twist off the screws on motor press
plate with screwdriver, and then
remove the motor press plate.
Remove the cross flow blade and
motor.
Pull out the shaft rubber cushion block.
Twist off the screws connecting the
cross flow blade and motor with
screwdriver, and then remove the
motor
.
Cross flow blade
Motor
Cross flow blade
Motor
Steps Procedure